Gas Hot Water System Installation

If your hot water system is 10 years old then it’s better to replace it. However, before purchasing a new hot water system try to solve the problem associated with the system. Most of the time, the problem can be solved by some repaire work. However, if your hot water system is leaking then it’s better to replace.
Gas water system installation might feel like a task for the pros, yet in fact, it's not as difficult as you might think. Certainly, the easiest means to do the job is to work with a specialist.

Tools as well as Material Needed for Gas Hot Water Installation
  1. Measuring tape as well as pencil
  2. Cable brush
  3. Utility knife
  4. Wrench.
5.3/ 8 ″ Nut motorist or a drill with a 3/8 ″ bit.
  1. Pipe Joint Substance: Gas plumbing tape (optional), or Teflon tape (optional).
  2. Self-touching sheet steel screws.
  3. Soap& Water: Drip discovery option.
  4. Quake Straps.
  5. Adjustable vent pipeline.
11.2 Versatile tubes.
  1. Adaptable gas line.
Best-Price-Hot-Water-Services-1024x540

A Few Points to Remember Prior To Mounting your Gas Water Heater
  • Inspect the tag on your old hot water heater. It should detail the yearly energy usage and also the container dimension. Both of these facts are valuable when you are selecting your brand-new water heater.
  • We advise examining your hot water heater vent system to make sure that it is appropriately functioning before eliminating your old system.
  • Disconnect and remove your old heater. Drain your heating system first and also use a hand vehicle to relocate outside.
  • If your tank has an excessive amount of sediment accumulation, the drain valve may clog.
  • Deal with the air vent pipe with treatment, if it is in good condition you can utilize it with your brand-new water heater.
  • If the Temperature/Pressure discharge pipeline remains in excellent repair work you ought to have the ability to reuse it as well.
  • If your hot water heater was plumbed with copper pipelines you might require to cut the copper pipelines with a tubing cutter. If so, make sure to leave as much pipe as possible.
  • We highly advise positioning your brand-new hot water heater into a drain pan as well as routing the water to a floor drainpipe.
  • Be sure to leave sufficient space to carry out routine maintenance on your brand-new water heater.

The Installation Process
  1. Drain the tank
  2. Disconnect the gas and water lines
  3. Detach the gas exhaust from the flue hat
  4. Set the new water heater in place
  5. Install the heat trap fittings
  6. Install water line connections
  7. Connect the gas supply line
  8. Test the gas line for leaks
  9. Light the pilot
  10. Turn the control knob on

We at best Price Hot Water provide the hot water system installation service at a very reasonable and economical cost. To know more about us, reach us directly through our official website bestpricehotwater.com.au.

Comments

Post a Comment